I only have one picture to report tonights progress. But this small amount of work took over three hours to complete. The framework of the standing sheet storage area only took about an hour, but it took over two hours to free up the framing material. This material was previously used for my standing sheet storage in the old shop. I sorted through all the material, idscarding much of it, and then moved the rest out of the way so I could remove the framework. I marked the shelf location in red that is the one remaining part of this rack that needs to be completed. I will use a plywood shelf suported by a cleat on the office wall. This will provide storage area below the shelf for sheets under 50" and the upper shelf will accept just short of 5 foot pieces.